Some customers had asked for a different range of sensitivity on the MT controllers.
To provide this a new board, Element 4.3, has been produced as a direct plug-in replacement for the original one.
The small blue pre-set control can be adjusted to give the range and feel required. No need to send back to us to modify.
It is easy to reach and adjust with a small screwdriver, but can't be accidentally changed, which ensures your settings remain.
The sensitivity adjustment works in the same way as before, but the range is adjusted via the start speed pre-set.
Clockwise increases the start speed
- Unscrew the six M2 Case crews
- Unscrew the two M2 nuts on the top of the old Board.
- Unplug the board taking care to pull it straight noting the 3-way connector as it uplugs.
- Plug in the new board and re-assemble.
Note that usually just a good clean of the original board and wiper contacts is all that is needed, so replacement may not be necessary.
TruSpeed - Element 4.3